tel: 0870 850 9111
Wadkin Delta six head moulders are affordable jointed machines devoloped to meet the needs of companies wishing to increase production and improve quality. The operator friendly Delta is designed for quick set-up and flexibility of operation. high specification features are standard with the Delta and combined with traditional engineering excellence, give life long reliability and high quality output.
HT DELTA PLUS (SHORT INFEED) - Head sequence: First bottom, fence side, near side, first top, second top and second bottom. Through-feed works and short infeed table with heavy duty 4-roll push feed works. Digital readout to spindle nuts, power rise and fall to top beam and pressures, pneumatic feed works and bed lubrication. Spindle speed 6000 rpm. Max finished work size 220 x 120 mm. Infinitely variable feed speeds 10 - 60 m/min powered by an 11 kW (15 HP) motor through electronic inverter (beltless). Eight motors: 11 kW (15 HP) each to first bottom, fence side and near side, 18 kW (25 HP) each to first and second top, 15 kW (20 HP) to second bottom and 11 kW (15 HP) to feed. (3 phase).
Factory remanufactured equipment from Wadkin is of the very highest standards. Each machine is stripped down from the cutting edge to the machine frame and then reassembled with any worn or defective parts replaced, beds reground, all health and safety aspects fully adhered too and repainted inside and out (in any livery you choose). After comprehensive testing the result is virtually indistinguishable from new.