tel: 0870 850 9111
If you require to machine short batches of long timber with varying width and thicknesses, quickly and economically, the GS is the answer you have been looking for. Designed with sawmilling appliacations in mind, the GS Planer Moulder has a short infeed table as standard and pneumatically linked infeed rollers for greater control and feeding.
The GS does not compromise on specifcation with mechanical digital readouts as standard and electrical rise and fall to the beam with a clutch for simultaneous top head adjustment for ease and quickness of setting.
GS220 - THROUGH-FEED WITH SHORT INFED TABLE (5 HEADS) - Head sequence: Bottom, fence side, nearside, top and second bottom. Driven infeed bed roller pneumatically linked to top driven feed works (cardan shaft). Power vertical adjustment to top head and pressures. Infinitely variable feed speeds 6 - 28 m/min (20 - 92 fpm). Max size of finished timber 220 x 120 mm. Cutterblock speed 6000 rpm. 2.2 kW (3 HP) motor to feed, 5.5 kW (7.5 HP) to each head except the top which is 7.5 kW (10 HP) (3 phase)
Factory remanufactured equipment from Wadkin is of the very highest standards. Each machine is stripped down from the cutting edge to the machine frame and then reassembled with any worn or defective parts replaced, beds reground, all health and safety aspects fully adhered too and repainted inside and out (in any livery you choose). After comprehensive testing the result is virtually indistinguishable from new