tel: 0870 850 9111

e-mail: info@wadkin.com

Wadkin Products

Images

Main Image for Wadkin NH Grinder

Image for Wadkin NH Grinder

Wadkin NH Grinder

This machine has been specially designed for the proper regrinding and maintaining of all the cutter equipment used on modern high speed woodworking machines. It will deal efficiently with all types of multi-knife cutter heads, as well as cutters for square or circular blocks, thick or thin planing knoves either in the blocks or independent of them. It is also capable of regrinding tungsten carbide tipped saws, tenoning machine cutterblocks and drills.

Specification

NH - The motorised head carries a grinding wheel at each end, will swivel 240 degrees and has rise and fall adjustment.  Compound sliding table for grinding knives up to 315 mm (12.5") long using dividing head arbor or up to 610 mm (24") long using vee blocks.  Will admit attachments for the regrinding and maintaining of all cutter equipment used on modern high speed woodworking machines.  1.5 kW (2 HP)  (3 phase).

Factory Rebuilt

Factory remanufactured equipment from Wadkin is of the very highest standards. Each machine is stripped down from the cutting edge to the machine frame and then reassembled with any worn or defective parts replaced, beds reground, all health and safety aspects fully adhered too and repainted inside and out (in any livery you choose). After comprehensive testing the result is virtually indistinguishable from new.


Information

Wadkin NH Grinder Literature

Wadkin NH Grinder Manual and Parts List

Spare parts enquiry form